Showing all 6 results
Gen 1/2 Coyote Oil Pan Kit
Ford Performance Oil Pan Replacement and Conversion Kit. This is a brand new 11-17 Oil Pan with Windage tray (gasket) with the Low Oil Level sensor deleted from it.
This is a direct replacement for all 11-17 Coyote Mustang and F-150 engines. This will also work on Generation 3 (18-21) Coyote Engines with the Power by the Hour Modified Pick up tube. So if you are looking to get rid of the stepped pan and go back to the easy fitment of the previous gen oil pans, then this is the ticket! Fits all hot rod applications, F-100s, 66-77 Bronco, 79-2010 Mustang with Coyote swap.
*PBH Modified Oil Pan Pick up tube required for use with this pan in 2018+ Coyote engines.(0 reviews)
Coyote Oil Pressure Sender Adapter
Coyote Swap Oil pressure sender adapter from Power by the Hour Performance. Fits all Generation Coyote Engines. Works with OEM Oil Filter housing as well as Canton Oil Filter adapter housing part # 22-627.
This sender adapter is necessary if you are using a Dakota Digital or other aftermarket cluster/sender where the use of multiple or the relocation of the one sender is necessary for clearance. This allows the use of the aftermarket sender as well as the factory unit to be used together.
Installation of this adapter does not require extending OEM oil pressure sending wiring and does not collide with any factory oil coolers, filters, or solenoids.
Both additional ports are 1/8″ NPT. One plug is included with the kit.
The PBH adapter accommodates both the 1/4″ pipe thread and M12x1.5 provisions of oem senders.(0 reviews)
-8 AN Flex LP Hose (No Scent) for Fuel System and Coolers 20FT
-8 AN Flex LP Line. Works with all Fuel Systems as well as Transmission/Power Steering Cooler Kits. No Scent line, so no fears of smelling up your garage. E85 Compatible, easy to use with AN compression fittings. 20 Foot Roll.
Works great in our fuel system and trans cooler kits!(0 reviews)
Fanned Transmission Cooler – Swaps/Street/Race Applications
Derale’s Quality Single Fanned Transmission/Oil Cooler with shroud is the go to on your high performance vehicle or swap application. Cooler comes with -8AN Male fittings which allows for easy adaptation to suit your needs!
Mounts easily to all 79-21 Mustangs under the headlight area in the front bumper cover.
Mounts to Early Bronco and F100 easily under the driver floor pan
Also easy to rear mount on the 05-21 Mustangs under the spare tire well with the Evap System removed
Universal Fitment/Application(0 reviews)
Trans Cooler Kit -8 AN
Trans Cooler kit comes complete with a Single Fanned Cooler, (4) -8an Straight fittings, (2) -8an ORB fittings from the cooler, and a 20 foot roll of -8 AN cooler lines. This is a universal fitment cooler. Can be run without the fan and shroud if desired. Sold separately is the Trans cooler fitting kit if this is to be installed with a 6r80 or 10r80 transmission.
Mounting Locations for the following vehicles: (custom bracketry may be required)
66-77 Bronco- Floor Pan under Driver or passenger seat.
05-14 Mustang and GT500 – Driver side of Front Bumper cover under headlight
05-21 Mustang- Remove EVAP assembly under spare tire well and install cooler in place. Note: Longer run of line required to make it to the back of the car.(0 reviews)