Ford Performance Gen 1 MANUAL Control pack 11-14 M-6017-A504VB

Code: m-6017-a504vb
Ford Performance Gen 1 MANUAL Control pack 11-14 M-6017-A504VB ls swaps coyote engine mustang speedsupplier

-

Ford Performance Gen 1 (2011-2014) Control Pack for all Coyote Engine’s with a Manual or Older Automatic Transmission . Works with all 11-14 Ford F-150 5.0L engines, as well as all 11-14 Ford Mustang GT 5.0L engines. For Use with the following transmissions: T-5, T-56, T-3650, TR-6060, TKO 500/600, TKX, 4R70W, C4, C6, 4R75W.

** Use of your Factory Engine harness from your Used/Takeout/Crate Engine is required. The Control pack does not supply one.

Currently on Back Order until APRIL 2022 (estimated)

Can be Tuned with HP tuners or SCT

*Note: use with 4R70/75 transmissions requires the use of a Us Shift Quick 4 Controller in addition to this control pack

$2,179.99

In Stock

Description

Ford Performance Gen 1 Manual Control pack for all 11-14 Coyote Engine swaps using a manual or early automatic transmission (non 6r80/10r80).

Kit comes with Pre Programmed ECU, Gas Pedal, Front 02 Sensors, Maf Sensor with Factory Air Box, brake switch, clutch switch, fuse box, and body harness to connect to your Ignition, Fan, and Fuel Pump sources for turn key operation.

Minimum fuel pump requirements are 255LPH Or greater and must use a RETURN style fuel system. a LS1 Corvette regulator will work, but we have seen them fail, so it is recommended that a traditional regulator is used to set fuel pressure and return.

 

Additional information

Weight 45 lbs
Dimensions 18 × 14 × 10 in

Reviews

There are no reviews yet.

Be the first to review “Ford Performance Gen 1 MANUAL Control pack 11-14 M-6017-A504VB”

Your email address will not be published.

Related products

  • Sale! Power by The Hour PBH-1100 Speed Drive Alternator Relocation for N/A 5.0L Coyote ls swaps coyote engine mustang speedsupplier
    • Power by The Hour PBH-1100 Speed Drive Alternator Relocation for N/A 5.0L Coyote ls swaps coyote engine mustang speedsupplier
    • Power by The Hour PBH-1100 Speed Drive Alternator Relocation for N/A 5.0L Coyote ls swaps coyote engine mustang speedsupplier
    • Power by The Hour PBH-1100 Speed Drive Alternator Relocation for N/A 5.0L Coyote ls swaps coyote engine mustang speedsupplier
    Coyote Swap

    Power by The Hour PBH-1100 Speed Drive Alternator Relocation for N/A 5.0L Coyote

    Power by the Hour Performance Coyote Alternator relocation kit is the solution for the tight fit in your resto-mod coyote swap. The Coyote alternator is known to hit the frame rails on Classic Mustang, Bronco, F100, and Lincoln swaps, requiring the need to move the alternator so you can sit this Coyote into your subframe.

    Included in the kit is the Alternator relocation bracket, Hardware, 2 Belt tensioners, and 2 Serpentine belts.

    Fits all 11-21 Coyote Engines – Mustang and F-150

    Requires the Use of a Mustang Alternator with Clutch-less pulley. Found only in the 11-17 AUTOMATIC GT cars. The use of the clutched pulley will result in a No-Charging scenario. We can sell you the correct pulley separately for $99.00 if using a Manual or Boss 302 Alternator kit.

    Requires the use of  a Mustang GT Balancer which is a 6 Rib/ 6 Rib design. 2015+ Ford F150 engines received a 6 Rib / 4 Rib balance which would need to be swapped out for the Mustang style.

    Requires the use of Ford’s Updated timing cover design from 2013-21. The Early 11-12 Timing covers had added bosses and grooves in the cover that interfere with this kit.

    Some grinding of the factory timing cover is required for the alternator case to clear.

     

    (0 reviews)
    $449.99

    -

    Add to cart
  • Sale! Trans Cooler Kit -8 AN ls swaps coyote engine mustang speedsupplier
    • Trans Cooler Kit -8 AN ls swaps coyote engine mustang speedsupplier
    • Trans Cooler Kit -8 AN ls swaps coyote engine mustang speedsupplier
    Coyote Swap

    Trans Cooler Kit -8 AN

    Trans Cooler kit comes complete with a Single Fanned Cooler, (4) -8an Straight fittings, (2) -8an ORB fittings from the cooler, and a 20 foot roll of -8 AN cooler lines. This is a universal fitment cooler. Can be run without the fan and shroud if desired. Sold separately is the Trans cooler fitting kit if this is to be installed with a 6r80 or 10r80 transmission.

    Mounting Locations for the following vehicles: (custom bracketry may be required)

    66-77 Bronco- Floor Pan under Driver or passenger seat.

    05-14 Mustang and GT500 – Driver side of Front Bumper cover under headlight

    05-21 Mustang- Remove EVAP assembly under spare tire well and install cooler in place. Note: Longer run of line required to make it to the back of the car.

     

    (0 reviews)
    $484.99

    -

    Add to cart
  • Sale! -8 AN Flex LP Hose (No Scent) for Fuel System and Coolers 20FT ls swaps coyote engine mustang speedsupplier
    • -8 AN Flex LP Hose (No Scent) for Fuel System and Coolers 20FT ls swaps coyote engine mustang speedsupplier
    • Tr Cooler -8AN 10ft hose ls swaps coyote engine mustang speedsupplier
    Coyote Swap

    -8 AN Flex LP Hose (No Scent) for Fuel System and Coolers 20FT

    -8 AN Flex LP Line. Works with all Fuel Systems as well as Transmission/Power Steering Cooler Kits. No Scent line, so no fears of smelling up your garage. E85 Compatible, easy to use with AN compression fittings. 20 Foot Roll.

    Works great in our fuel system and trans cooler kits!

    (0 reviews)
    $121.90

    -

    Add to cart
  • Sale! Aeromotive Phantom 340 Stealth Fuel System – 18688 ls swaps coyote engine mustang speedsupplier
    • Aeromotive Phantom 340 Stealth Fuel System – 18688 ls swaps coyote engine mustang speedsupplier
    • Aeromotive Phantom 340 Stealth Fuel System – 18688 ls swaps coyote engine mustang speedsupplier
    • Aeromotive Phantom 340 Stealth Fuel System – 18688 ls swaps coyote engine mustang speedsupplier
    Aeromotive

    Aeromotive Phantom 340 Stealth Fuel System – 18688

    Aeromotive Phantom Stealth Single 340LPH assembly is perfect for your Naturally aspirated or low boost application. Return Style hat with -6 AN Ports, comes complete with instructions, template, installation hardware, fuel pump and hat, and the sock. Will fit virtually any fuel tank from 5.5 inches to 11 inches deep. Works with Fuel cells as well! This set up is great for LS and Coyote swap candidates, as well as Vintage Bronco, F100, and Mustang’s. By running an intank pump the risk of it burning out on extended trips is virtually non existent. Do not get stuck running a loud external pump, grab this Phantom kit today!

    (0 reviews)
    $554.99

    -

    Add to cart