Trans Cooler kit comes complete with a Single Fanned Cooler, (4) -8an Straight fittings, (2) -8an ORB fittings from the cooler, and a 20 foot roll of -8 AN cooler lines. This is a universal fitment cooler. Can be run without the fan and shroud if desired. Sold separately is the Trans cooler fitting kit if this is to be installed with a 6r80 or 10r80 transmission.
Mounting Locations for the following vehicles: (custom bracketry may be required)
66-77 Bronco- Floor Pan under Driver or passenger seat.
05-14 Mustang and GT500 – Driver side of Front Bumper cover under headlight
05-21 Mustang- Remove EVAP assembly under spare tire well and install cooler in place. Note: Longer run of line required to make it to the back of the car.
Ideal for Coyote and LS Swaps ! These Single 340LPH Phantom Stealth hats are internally regulated to 58 PSI, making this ideal for your swap needs. All Gen 1 and 2 Coyotes Require 55-58 PSI At Startup, so if you are looking for a clean set up to run one fuel line up to the fuel rails without the need for the return, then this is the ticket for you.
Comes with all instructions, template, mounting hardware, fuel pump sock (yellow sponge part, trim to fit).
Fits virtually any fuel tank or fuel cell that is 5.5″ to 11″ Deep. -6 AN Ports on fuel hat.
Recommended for Naturally Aspirated Applications making under 600 HP.
For Supercharged and other Forced Induction applications please look at SS-18309 for the Dual 340LPH system.
Low Profile Accessory Bracket kit. For use with Sanden SD7 AC Compressor and Ford Modular Power steering pump. Ideal in all Vintage Bronco, Lincoln, Street Rod, and F100 Swaps.
Kit includes: Alternator Relocation Bracket, Power Steering Bracket, SD7 Bracket, 2 Belt Tensioners, Serpentine belts, and mounting hardware.
*Requires the use of a 2011-21 Coyote Mustang Alternator from an Automatic Equipped GT, if using a Manual alternator then we can sell the correct pulley to add to the kit
*Requires the use of a 2013+ Ford Mustang Timing Cover
Reviews
There are no reviews yet.